Physical server setup

From PrgmrWiki
Revision as of 06:25, 4 February 2011 by Nick (talk | contribs)

switch setup

The dell, cisco (except for catos), hp and foundry switches all use a fairly similar cisco ios-like syntax. CatOS is totally different (and evil). These examples are from a cisco 3750 but other ios-like switch command lines are similar.

  • set the switch port to the right vlan
daiba#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
daiba(config)#interface GigabitEthernet1/0/2
daiba(config-if)#switchport mode access
daiba(config-if)#switchport access vlan 42
  • set the port description to the hostname of the server
daiba(config-if)#description exampleserver.prgmr.com
  • The new configuration is now active, but it should be saved.
daiba(config-if)#exit
daiba(config)#exit
daiba#
32w4d: %SYS-5-CONFIG_I: Configured from console by console              
daiba#copy run start
Destination filename [startup-config]? 
Building configuration...
[OK]
daiba#

console server setup

The opengear console server ports should be configured with the gui. The cyclades ts series

pdu setup

turn on the port

set the name of the port to the hostname

pxe setup

add the host to dhcpd.conf on the appropriate dhcp server

setup a pxe configuration file named as the mac address in the tftpboot directory

make a kickstart file referred from the pxe configuration file

network boot the server